Milliput
Black Milliput is the most recent addition to our range of products. Ideal if you want to match a black surface without painting it afterwards. Once cured the beauty of Milliput is that it can be drilled, filed and sanded while still retaining its adhesive properties and bonding strength.
The two sticks have a long shelf life but once mixed the resultant putty is at first soft and highly adhesive and then gradually hardens. Speed of hardening is dependant on temperature and at normal temperatures (20-25ºC) Milliput becomes rock hard in three to four hours. By the application of heat the setting time can be reduced to a few minutes.
After setting hard Milliput continues to cure and is fully cured after an elapse of time equal to the setting time at the same temperature. Once fully cured Milliput can be machined, drilled, tapped, turned, filed, sawn, sandpapered and painted. Milliput can be sandpapered and painted immediately it has set. (it is advisable to wear eye protection during this process).
Milliput is an excellent adhesive and will bond any of the following to itself or to any of the others – wood, brick, cement, metals, concrete, plastics, glass etc, but note that Milliput is not intended as a thin layer adhesive and should not be used where a paste, mucilage or thin glue is indicated. Milliput will set under water and is heat resistant up to 130°C.
Typical applications:
- Repair of antique clocks
- Guttering
- Ebonised wood
- Marble
- Slate
- Cast Iron
- Basalt ceramics
- Black plastic parts
- Automotive applications
- Jewellery making
